Auteur Sujet: Almost perfectly calibrated! - Tree Frog prints  (Lu 449 fois)

ryandgarrison

  • Newbie
  • *
  • Messages: 1
    • Voir le profil
Almost perfectly calibrated! - Tree Frog prints
« le: 03 septembre, 2016, 11:04:51 pm »
Using Simplify3D, I printed two tree frogs on my homemade SmartrapCore. One is 0.2 mm resolution, the other is 0.1 mm resolution.

I previously printed 3 others and once I perfected some settings on the slicer, these were my best prints!

Thought I'd share.

Loggs

  • Full Member
  • ***
  • Messages: 146
    • Voir le profil
Re : Almost perfectly calibrated! - Tree Frog prints
« Réponse #1 le: 21 octobre, 2016, 04:14:17 pm »
Great ! I have some questions about your configuration:
- Do you use a fan duct ?
- Do you print them with support ?

Thanks ;)

Fred_replicant

  • Hero Member
  • *****
  • Messages: 833
    • Voir le profil
Re : Almost perfectly calibrated! - Tree Frog prints
« Réponse #2 le: 22 octobre, 2016, 07:36:30 pm »
Good job !  ;)
Smartrap Orange V 0.4.9.2 Jheadlite 0.35 GT2
(mais bon, je vais la démonter ....snif)

CORE 50X50 Fred_Design